Bankers Box Dimensions Compared: Letter vs Legal, Depth Options, and Brand vs Generic
Why I'm Comparing Bankers Box Dimensions This Way
I've ordered the wrong Bankers Box more times than I care to admit. Not because the product is complicated—it isn't—but because I kept assuming "file box" meant one thing. It doesn't. Once you factor in letter vs. legal width, standard vs. deep depth, and brand-name corrugated vs. the generic stuff, you're looking at maybe a dozen variations that all look the same on a screen.
So here's the comparison I wish I'd had. Three dimensions that actually decide whether a box works for your files, your shelving, and your budget. Not a spec sheet dump—just where each option wins and where it doesn't.
I'm comparing: (1) letter width vs. legal width, (2) 10-inch vs. 15-inch vs. 24-inch depth, and (3) Fellowes Bankers Box vs. generic corrugated. Same files, same shelves, very different results.
Dimension 1: Letter Width vs. Legal Width
This one sounds obvious until you've watched a legal-size box swallow a letter-size file sideways.
Letter Width (fits 8.5 × 11)
Standard letter Bankers Boxes run roughly 15" L × 12" W × 10" H on the outside. The interior is sized so a hanging folder or a stack of 8.5 × 11 paper sits flush. Files stay upright, labels face out, and when you pull one box off the shelf, the contents don't shift.
Legal Width (fits 8.5 × 14)
Legal boxes are the same length and height but wider—about 15" across instead of 12". They exist for one reason: legal-size documents and the hanging folders that hold them. If you're storing contracts, court filings, or anything that doesn't fit letter width, this is the size you need.
The comparison
Letter wins on density. You fit more of them on a shelf, they're lighter when loaded, and they cost less per unit. Legal wins on compatibility—if your files are legal-size, letter boxes are useless, full stop.
The mistake I made: In my first year, I ordered 40 legal-width boxes for what turned out to be letter-size files. Looked fine on the purchase order. When we loaded them, every file leaned. We ended up stuffing foam inserts to keep things upright—about $340 wasted on oversized boxes plus a week of fiddling before I reordered.
My rule now: measure a representative folder before you order. Not the paper—the folder. Hanging folders add width, and that's what actually decides letter vs. legal.
Dimension 2: 10-Inch vs. 15-Inch vs. 24-Inch Depth
Depth is the dimension people ignore, and it's the one that causes the most expensive reorders because depth determines whether the box fits your shelving.
10-Inch Depth
This is the standard. Fits 12" and 15" shelving with room to spare, stacks predictably, and matches most records-management shelving systems. Letter-size 10-inch boxes hold roughly 1.5 cubic feet—about a full file drawer compressed.
15-Inch Depth
A middle option for legal files or heavier loads. Costs more, holds more, but the extra depth means fewer boxes fit per shelf. Useful when you're archiving long-term and want fewer physical boxes to track.
24-Inch Depth
These are the deep boxes—often called "deep legal" or "transfer files." Great for bulk storage, terrible for standard shelving. A 24-inch box on a 15-inch shelf hangs off the front, which is exactly as unsafe as it sounds.
The comparison
10-inch wins for shelving compatibility and per-shelf density. 24-inch wins for raw capacity per box but only if your shelving is actually deep enough. 15-inch is the compromise that rarely gets chosen but occasionally solves a specific problem.
In September 2022 I ordered 60 boxes at 24-inch depth because they were on sale. Our shelving was 12-inch. I didn't check. They sat on the floor for three weeks while I argued with the shelving vendor. Ended up shipping them back at my own cost—$220 in return shipping and a 9-day delay on the archive project.
Here's the thing nobody tells you: the box is rarely the bottleneck. The shelf is. Measure the shelf first, then pick depth. If I remember correctly, our current shelving is 15-inch, and 10-inch boxes leave just enough gap to grab the handle. Though I might be misremembering—I'd have to measure.
Dimension 3: Fellowes Bankers Box vs. Generic Corrugated
This is where the cost conversation actually happens, and it's more nuanced than "brand is better."
Fellowes Bankers Box
Standardized sizes, consistent double-wall bottom construction on most models, and built-in handles that don't tear out. If you're stacking four high on a shelf and pulling boxes once a quarter, the construction holds. The price runs roughly $3–6 per box at retail, with bulk pricing dropping toward $2–3 at higher quantities. Based on current retail listings—verify current rates, since corrugated pricing moves with pulp costs.
Generic Corrugated
Cheaper—often $1.50–3 per box—and functionally similar for light, short-term storage. The difference shows up in the bottom seams and the stacking strength. Generic single-wall boxes tend to sag when stacked more than two high under load, and the handholds are usually just die-cut holes without reinforcement.
The comparison
For short-term storage (under a year), low stacking, and light files, generic corrugated is fine. For long-term archive, high stacking, or frequent retrieval, the brand-name construction pays for itself the first time a stack doesn't collapse.
The conventional wisdom is that storage boxes are commodity items—buy the cheapest. My experience after about 200 boxes in seven years says otherwise. We had a generic stack collapse in 2021 under a water pipe leak. Twelve boxes of client records soaked through because the boxes had no structural rigidity when wet. The reorder plus the damaged files cost more than the difference between generic and branded for the entire annual order.
I'm not saying branded boxes are magic. I'm saying the failure mode of cheap boxes is expensive and happens at the worst time.
Price vs. Total Cost: A Dimension Most Comparisons Skip
Unit price is the easiest number to compare and the least useful on its own. Here's what actually lands on the invoice:
- Unit price: $1.50–6 depending on brand and quantity
- Reordering cost: if you guessed the wrong size, you pay shipping twice
- Damage cost: collapsed boxes = damaged files = potentially irreplaceable records
- Labor cost: poorly fitting boxes take longer to load and retrieve
A $2 generic box that fails in 14 months costs more than a $4 branded box that lasts five years—provided you picked the right dimensions. Wrong dimensions negate the whole calculation. That's the part I keep relearning.
So Which Bankers Box Do You Actually Need?
Scene-based, since there's no universal "best" box:
If you're filing letter-size paper on standard 12–15" shelving: 10-inch depth, letter width, brand-name if you'll stack more than two high. This is the default for a reason.
If you're storing legal documents: legal width, 10-inch depth unless you need the extra capacity—then 15-inch. Check your shelving depth before ordering anything deeper.
If you're doing short-term storage and won't stack high: generic corrugated is genuinely fine. Don't overpay for durability you won't use.
If you're archiving long-term in a records room: branded boxes, 10-inch depth, letter or legal width as needed. The failure cost is too high to gamble on the cheapest option.
The honest answer is that dimensions matter more than brand. Get the width and depth right, and a generic box will do the job for most situations. Get them wrong, and the most expensive box on the market won't save you. I've learned that one the hard way—more than once.
Ready to Explore Print-on-Demand?
Get a personalized cost analysis and publishing strategy consultation from Lightning Source experts
View Our Services